I’ve actually gotten much better about this over the last year or two, but still. Sometimes you’re in a rush and forget till the dryer wakes up the whole family 😅
I just upgraded from those little stubby ones to 6" ones. Much easier to manage. I repurposed an old drill bit case for them. Now I have a case of 6" SAE and one of metric.
Metrics are orange, SAE blue - on the shaft, from the vendor, comes with a handle too. Kit was $30 on Amazon.
I’ll still miss the impact bit until it’s in the dryer
T25?
One of the principal offenders for sure
I’d say that, a normal Phillips, and/or a 5/16 are the usual suspects.
Use a separate foreskin for each bit, paint each a different color. Easier to identify, easier to change, harder to lose.
Also, have some long foreskins too.
That’s good advice.
I’ve actually gotten much better about this over the last year or two, but still. Sometimes you’re in a rush and forget till the dryer wakes up the whole family 😅
Sonofabitch
Hahahahahaja
Oh, those bits.
I just upgraded from those little stubby ones to 6" ones. Much easier to manage. I repurposed an old drill bit case for them. Now I have a case of 6" SAE and one of metric.
Metrics are orange, SAE blue - on the shaft, from the vendor, comes with a handle too. Kit was $30 on Amazon.