cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 6 months agoMIT researchers crack 3D printing with glass — new technique enables inorganic composite glass printed at low temperatureswww.tomshardware.comexternal-linkmessage-square17fedilinkarrow-up1165arrow-down12
arrow-up1163arrow-down1external-linkMIT researchers crack 3D printing with glass — new technique enables inorganic composite glass printed at low temperatureswww.tomshardware.comcm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 6 months agomessage-square17fedilink
minus-squaresuswrkr@discuss.tchncs.delinkfedilinkEnglisharrow-up1arrow-down7·6 months ago250C is not low temp for 3D printing tho, noticed that in headline. sure that is low temp for glass aber above the PLA, ABS, ASA temps i run in vorons.
minus-squarecepelinas@sopuli.xyzlinkfedilinkEnglisharrow-up4·6 months agoGlass (some not all) melts at more than 1000 C I think that’s hell of a lot harder to print at than 250 C even Prusa PETG prints at that temp.
minus-squareBluewing@lemmy.worldlinkfedilinkEnglisharrow-up2·6 months agoThey stated 250C was for annealing to final product. That’s a temperature any bog standard toaster oven or kitchen oven can do. Sadly, they said nothing I saw about actual extrusion temps.
250C is not low temp for 3D printing tho, noticed that in headline.
sure that is low temp for glass aber above the PLA, ABS, ASA temps i run in vorons.
Glass (some not all) melts at more than 1000 C I think that’s hell of a lot harder to print at than 250 C even Prusa PETG prints at that temp.
They stated 250C was for annealing to final product. That’s a temperature any bog standard toaster oven or kitchen oven can do. Sadly, they said nothing I saw about actual extrusion temps.