I stripped this screw in my laptop and as such can’t open the back cover to replace parts.

Things I’ve tried: -Different size/type screwdrivers -Rubber band -Hammer -Hot glue gun

Edit: got it unsuck. Thanks everyone for the advice

  • dohpaz42@lemmy.worldEnglish
    0·
    3 months ago

    Use a rubber band. Place it flat against the screw head and then use your screwdriver. You can also fill the screw head with baking soda, imprint your screwdriver in the baking soda, then cover with superglue. That should create a new surface for the screwdriver to catch on. If neither doesn’t work, then use the more expensive solutions.

  • isolatedscotch@discuss.tchncs.de
    0·
    3 months ago

    if you don’t mind if having to buy a new screw, there are specialized stripped screw extractor bits for drills where one end makes a hole and the other grips the screw and takes it out, they can be bought on aliexpress for dirt cheap

      • NABDad@lemmy.worldEnglish
        1·
        3 months ago

        This is the way.

        I received some bad screws in a high-end monitor mount for medical diagnostic monitors. The tech who was mounting the monitor didn’t realize, and tried to use gorilla strength to drive the screw in. He broke the head of the screw off.

        The monitor in question was a brand new, $13,000 monitor. We needed it, and we couldn’t wait to ship it back to the manufacturer to get the screw removed.

        I got the smallest set of screw extractors I could buy, wrapped the monitor in plastic with a hole over the screw. I put a piece of tape over the hole so that everything was sealed with only the screw exposed.

        I went very slow and very gentle, vacuuming up any bits of metal shavings before fully removing the screw, but it went fine.

        It was quite a butt-puckering operation, but I survived it.