• RememberTheApollo_@lemmy.world
    link
    fedilink
    arrow-up
    30
    ·
    7 个月前

    Those were great. They did a job for everyone that couldn’t afford the latest tech in the car. Now you’re lucky to get a head unit with an Aux plug, much less a CD player.

    • ChickenLadyLovesLife@lemmy.world
      link
      fedilink
      English
      arrow-up
      5
      ·
      7 个月前

      I drive a 2001 which luckily came with a CD player that was wired to use a 6-disc changer mounted in the trunk. For $50 I got an adapter cable that tricks the unit into thinking my aux device is the 6-disc changer. This worked great until I got my latest phone which doesn’t have a fucking headphone jack. I bought an adapter but the top volume level is pitifully low, so I’m back to burning CDs to play in my car.

      • mic_check_one_two@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        4
        ·
        7 个月前

        I bought an adapter but the top volume level is pitifully low, so I’m back to burning CDs to play in my car.

        This is odd, because the voltage levels should be somewhat normalized across the USB-C adapter and your old headphone jack. It may be an issue with your adapter having a shitty DAC. Basically, the adapter has to take the digital audio signal, and convert it to analog. Cheaper adapters will use cheap digital-analog converters (DACs) which will either output lower levels, or will tend to change the signal as volume increases.

        It’s also possible that it is purely an analog converter, in which case your phone is actually using its internal DAC. There are benefits and drawbacks to this, but it’s possible that your phone is software-limiting its internal DAC’s power output to avoid burning out from a bad connection.

    • SubArcticTundra@lemmy.ml
      link
      fedilink
      arrow-up
      2
      ·
      7 个月前

      I think it’e because of how long ago it was. I feel like society hasn’t changed very much since ~2012 (last time this was necessary) so it all feels like one long continuous blur. And then you realize that was 13 years ago.

  • potoooooooo ✅️@lemmy.world
    link
    fedilink
    English
    arrow-up
    25
    ·
    7 个月前

    Psshhht. I used to have a microphone that let me SING ON THE RADIO. It literally put me on the FM airwaves. You may have heard some of my stuff.

    • Schadrach@lemmy.sdf.org
      link
      fedilink
      English
      arrow-up
      4
      ·
      7 个月前

      I can see the use if you’re for example driving an older car with mostly original kit and don’t want an anachronistic stereo in it. So you pair up your fake cassette to your modern phone and can still play Spotify or w/e with the original kit.

      There’s even an 8-Track version of it.

      • Count Regal Inkwell@pawb.social
        link
        fedilink
        arrow-up
        6
        ·
        edit-2
        7 个月前

        Also buying a whole-ass new car stereo (+ installation) is much more expensive than a bluetooth adaptor from China

        So if you’re driving an ancient car out of necessity rather than for the aesthetic, this can help you get music into it.

        F’course

        Most cars from the age of tapes nowadays are relics. “Old cars” in the range that poor people drive out of necessity are from the CD age instead.

        • vaultdweller013@sh.itjust.works
          link
          fedilink
          arrow-up
          2
          ·
          7 个月前

          You’d be surprised, I’ve seen cars from as late as 08 that still had cassette. Though that’s probably heavily dependent on manufacturer, model, region, and sub model type. But my point still stands, hell id wouldn’t be surprised if there was a car or two manufactured in 2012 that still came stock with a cassette deck.

    • CarrotsHaveEars@lemmy.ml
      link
      fedilink
      arrow-up
      2
      ·
      7 个月前

      How does that work from the fake cassette to the player? Does the fake cassette record what’s streaming to it to a loop of tape and let the player pick up the audio?

      • Count Regal Inkwell@pawb.social
        link
        fedilink
        arrow-up
        5
        ·
        edit-2
        7 个月前

        adjusts 🤓 glasses

        So a cassette tape works by using electromagnetism. Ferric Oxide (AKA, literally rust powder) has a property that if exposed to a magnetic field, it will create a weak version of that magnetic field within itself

        So the record head of a tape machine is an electromagnet that changes its field based on the actual audio signal, translating audio frequencies directly to magnetic directions and strengths, while the read head is a passive electromagnetic coil that picks up that weak magnetic field on the rust-coated plastic tape while a small motor runs the tape past it and emits it as a soundwave.

        The tape adapter skips 90% of these steps —

        — It just has an electromagnetic coil of its own, positioned so it lines up with the play head, and when you feed it an audio signal, that audio signal gets directly translated to a magnetic field just by running it through the coil. The tape deck picks it up and doesn’t even realise there is no tape running through

    • Buddahriffic@lemmy.world
      link
      fedilink
      arrow-up
      2
      arrow-down
      2
      ·
      7 个月前

      I got one of those USB dongles that can charge and output analog sound to aux.

      There’s a whine that matches my RPMs because the thing doesn’t isolate the voltage from the charger and the audio signal that well. Luckily it isn’t very audible when it’s being driven (the sound, not the car). Oh I also need to unlock my phone before it even drives it and it takes a bit for it to switch over.

      The phone needs to convert to analog to drive the speakers anyways, just fucking stick a mux on that to decide whether it drives the speaker amp or an aux wire. If the jack was too thick, imo it would have been better to introduce a new smaller analog jack standard.

  • Bruhh@lemmy.world
    link
    fedilink
    arrow-up
    9
    ·
    7 个月前

    I have one that is bluetooth to cassette. Unfortunately, it has a lot of artifacts during playback. Opted for a bluetooth transmitter that connects to an empty radio channel? Frequency? Works well.

    • Vytle@lemmy.world
      link
      fedilink
      arrow-up
      1
      ·
      7 个月前

      Sounds like an issue with your cassette deck. You should definitely be getting better audio quality with a cassette adapter, mine sounds better than a normal cassette tape. Every radio frequency transmitter I have ever tried has had severe artifacting on the high end (treble), especially prevalent on “S” sounds; they come out really static-y. At any rate, your better off doing literally anything else than repairing your cassette deck if it’s cooked, but its worth a go to try a standard aux cord cassette since they’re under $10.

      I’ve actually opted to record my playlists onto cassette tapes, and I wound up using these more than the aux adapter.

    • GooberEar@lemmy.wtf
      link
      fedilink
      English
      arrow-up
      2
      ·
      7 个月前

      The bluetooth to FM transmitter works well for you? I’ve tried them several times over the decades, even the expensive ones seem to suck. Maybe not as much as your bluetooth to cassette, I’ve never seen one of those for sale or used one.

      • Bruhh@lemmy.world
        link
        fedilink
        arrow-up
        1
        ·
        7 个月前

        What issues have you had? Mine connects fine without issue and the quality is ok at best but my car speakers aren’t exactly preem. My antenna is even broken off and has a hard time catching regular stations but no issues with my transmitter nor with the bluetooth part of it.

        • GooberEar@lemmy.wtf
          link
          fedilink
          English
          arrow-up
          2
          ·
          7 个月前

          There’s always some degree of background static, hissing, humming, etc, no matter what channels I tried tuning them to. I don’t expect perfectly clear audio while using an adapter, but those tuner types were always unacceptably bad for that any time I’ve tried them.

  • Diplomjodler@lemmy.world
    link
    fedilink
    arrow-up
    30
    arrow-down
    2
    ·
    7 个月前

    I had one of those too. I don’t miss it at all, though, because the sound quality was dogshit. Now get off my lawn, damn kids!

    • Curiousfur@lemmy.world
      link
      fedilink
      arrow-up
      13
      ·
      7 个月前

      You may have missed the protective film on the magnet head. When I had one, it was a night and day difference once I got the protective film off.

    • Björn@swg-empire.de
      link
      fedilink
      arrow-up
      7
      ·
      7 个月前

      Strange. The quality should be about the best a cassette or aux cable could deliver. They are basically just two electromagnets controlled by the audiosignal.

      They are so simple there isn’t a lot to do badly.

  • michaelmrose@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    7 个月前

    So the thing about these is they always work unless you physically damage it in a completely obvious way and then you get another $5 adapter. You know unlike figuring out how to make your phone talk to a stupid car.

  • TBi@lemmy.world
    link
    fedilink
    arrow-up
    1
    ·
    7 个月前

    I remember excluding cars with CD players from my purchasing decisions for this reason! Should either have a tape or aux in.